Webasto Thermo Top Start 5 kW + MiniTimer (Restored)

Buy Webasto Thermo Top Start 5 kW + MiniTimer (Restored)

Prestarting heater Webasto Thermo Top Start It is intended for:
• car engine preheating liquid cooling.
Ideal for cars with engine capacity of 2 to 4 liters.
Item No. 1321467B
Альтернативные номера: 9015858A, 1318019B

In stock
$641.67 $250

Prestarting heater Webasto Thermo Top Start

Has a significantly smaller dimensions than the previous model, which allows you to install the heater in modern cars with extremely tight linkage of under-bonnet space. Engineers were able to reduce not only the overall dimensions, but also reduce fuel consumption by 30% compared with a series of Thermo Top C. Low cost, high teploproizvodimost, minimum dimensions and light weight made Top Evo 5 flagship among heaters for cars. Designed for cars with engine capacity of 2 to 4 liters.

Supplied with the heater:

  1. Heater to replace the Thermo Top Start 5 12V petrol 5 kW
  2. circulation pump U 4847 econ 12V (OE 18 mm
  3. Pump-dispenser DP 42 12V (petrol and diesel) with mounting hardware
  4. set fittings for connecting the heater 2 x 900 OE18mm, two spring collar OE25mm 2pcs-90 deg. h18mm
  5. Pack with connecting fittings. Composition: corner fitting 900 x-2 PCs samozazhimnoj OE25mm yoke-6 PCs
  6. Pack with connecting fittings. Composition: corner fitting 900-OE18h18mm-1 PC socket direct OE18h18 mm-1 PC clamp 25 mm OE samozazhimnoj-6 PCs
  7. liquid Hose L = m OEvnutr = 18 mm, OEvnesh = 18 mm8-nozzles for liquid pressure plate, two rubber seals, mounting screws
  8. Pack with circulation pump U4847 econ, M6 cage nut M6 bolt bushing
  9. Pack with exhaust clamps and mounting hardware
  10. package with mounting hardware
  11. exhaust Pipe D = 22, d = 25.5, L = 1000 mm
  12. package with remote, metallized heat rings (red) 2 PCs.
  13. air intake Tube OEvnutr 21.4 mm, L = 400 mm.
  14. Pack cable ties. 40 PCs
  15. standard Bracket17-pack connectors fuel nozzles
  16. main wiring Tow (sealed)19-cartridge fuse and relays (inside)
  17. Tow circulation pump
  18. Package with elements for power connection fan motor the oven compartment
  19. package with fuel intake
  20. the fuel tube, black 1, 5x5mm, L = 5 m.
  21. Pack with documentation

Structure of the heater Webasto Thermo Top Comfort+.

Webasto Thermo Top Start 5 consists of the next main components:

- The air supercharger with the control unit. Dismantling of the supercharger isn't admissible!

- Torch

- Heat exchanger

- Pin flame heat / sensor

- Temperature sensor and sensor of overheating

- Circulation pulser

- Pump batcher.

Operation principle Webasto Thermo Top Comfort+.

Start of the heater happens through a signal on inclusion from governing body. Thermo Top Evo can be started only by means of the governing body possessing the tire WBus or by means of PC diagnostics of Thermo Test. At start of the heater the supercharger, the circulation pulser and a pin of heat begin to function. Then the pump batcher turns on. The petrol heater is started with the maximum load. The diesel heater is started with the minimum loading and slowly accelerating, passes to the maximum load. During a start phase the pin of heat controls formation of a flame. After an exit to the mode of the maximum load the pin of heat performs the controlling function of the sensor of a flame. The heater from achievement of a certain temperature (about 55 °C) passes into the energy saving mode of partial loading. If temperature increases and further, then the heater from a certain temperature (about 84 °C) is switched off in the mode of an adjusting pause. Process of burning stops when receiving a signal on switching off, at achievement of extreme temperature of burning, at achievement of the set operating time or at emergence of a mistake.

Re-activation is possible only when the coolant temperature drops to 55°C



Non EU certificatese1*2001/56*2006/119*0258*... e1*72/245*2006/96*5627*...E1 122R-00 0258E1 10 R-03 5627
DesignSolvent evaporation from burner heater
Heating capacityFull load / Partial load 5,0 kW2,8 kW 5,0 kW2,5 kW
FuelPetrol EN 228DIN 51625Diesel EN 590
Fuel consumption+/- 10 %Full load / Partial load 0,705 l/h0,395 l/h 0,620 l/h0,310 l/h
Nominal voltage12 V
Operating voltage range11 - 16,5V
Nominal power consumption without circulation pump+/-10% (without fan)Full load / Partial load 33 W15 W 33 W12 W
Permissible ambient temperature Wednesday: Heater-workStorage Metering pump:-operation-storage-40 ... +60 °C-40 ... +120 °C-40 ... +20 °C-40 ... +10 °C-40 ... +90 °C-40 ... +80 °C-40 ... +120 °C-40 ... +30 °C-40 ... +90 °C
Permissible operating pressure of the coolant2,5 bar
Volume heat exchanger0,075 l
1,50 l
200 l/h
CO2 in the waste gas (valid range)8 - 12,0 % of volume
Heater dimensions without mounting parts (tolerance ± 3 mm)L = 218 ммB = 91 ммH = 147 мм without fittings
Weight/unit with mounting kit2,1 kg / 8 kg
Manufacturer Webasto
Country of origin Germany
Weight 8 kg

Categories: Prestarting heaters Webasto

Webasto Thermo Top Start 5 kW + MiniTimer (Restored) reviews

Be the first to write a review of this product!