Temperature sensor 5m
Temperature sensor, cable length 5m
Applicability: Webasto Air Top 2000ST
Delivery set: Includes electrical plugs
Used for control of temperature, in a case when the heater is located in a distance from the room which warms.
Important! For use with a standard plait of wires 9003696E
During repair or the routine technical maintenance of heaters can be in addition made the following work on re-equipment:
• Installation of the external sensor of temperature.
General information.
The heater optimum maintains desirable temperature if air temperature, flowing round temperature sensor, is close to air temperature in those rooms which need to be warmed up. But it isn't always possible, first of all because of features of an installation site of the heater. The external sensor of temperature which is installed directly in the corresponding part of the room is in that case used.
Installation.
Installation is made as follows:
1. To choose an installation site for the external sensor of temperature.
Instruction:
• Temperature sensor on has to be installed so that it was directly blown by a stream of warm air, and not near heat sources (for example, the regular heater of the car);
• He should be established at average height in a cabin of the car and on a surface as close as possible to vertical;
• The installation site shouldn't be in an area of coverage of direct sunshine;
• The sensor of temperature shouldn't be installed curtains, etc.
2. To lay a plait from the external temperature sensor to governing body.
3. To remove resistance on a plait to be near the socket on governing body.
4. To pressure up a X8 socket block instead of remote resistance.
5. To connect the portable temperature sensor to a X8 socket block.
6. To turn on the heater and to check operation of the heater.
Manufacturer | Webasto |
Country of origin | Germany |
Weight | 0.2 kg |
Temperature sensor 5m reviews
Be the first to write a review of this product!