Overheat Temperature Sensor for Air Top Evo 3900/5500
Overheat temperature sensor.
The limiter of heating protects the heater from inadmissible overheating in the course of work. It works at a temperature over 150 °C, disconnects an electric chain of the dosing pump and switches-off the heater, transferring him to the purge mode. After cooling the electric chain becomes isolated again. Again to start the heater after operation of the limiter of heating, it needs to be switched off, and then again to include.
Replacement of the sensor of overheating.
Dismantling.
1. To uncover.
2. To remove laying.
3. To switch-off the heating limiter plug on the control unit.
Instruction: The limiter of heating can be in addition fixed by a washer. This washer at installation needs to be replaced with new.
4. To remove the screw and if she is, a washer.
5. To remove the overheat temperature sensor.
6. To carry out works with the removed components.
Installation.
ATTENTION! The limiter of heating needs to be installed by a touch element to the heat exchanger.
1. To install the overheat temperature sensor and to fix by the screw and if it is necessary, a washer.
2. To tighten the screw with the moment 2,5 ± 0,25 Nanometers.
3. To connect the overheat temperature sensor plug on the control unit.
4. To put on laying.
5. To establish a cover.
Manufacturer | Webasto |
Country of origin | Germany |
Weight | 0.1 kg |
Overheat Temperature Sensor for Air Top Evo 3900/5500 reviews
Be the first to write a review of this product!