Flame Detector Thermo 230/300/350 DW230/300/350
Flame detector.
The flame detector controls a condition of a flame during all process of burning and represents the photo diode which changes resistance depending on flame luminous intensity. Signals are given in the control unit and processed in it.
Check of resistance of the flame detector.
The glass guard and peephole of the flame detector should be cleaned from pollution. If the flame detector is damaged or his resistance is lower than norm, he should be replaced.
Check.
1. to close a flame detector peephole.
2. to check resistance (norm <20 kOhm).
3. to open a peephole of the flame detector and to light the sensor with a strong lamp.
4. to check resistance (norm <400 Ohms).
Replacement of the sensor of a flame.
Instruction: Replacement of the flame detector in the heater installed in the car and removed from him is made equally.
Dismantling.
1. If it is necessary, to remove a burner.
2. The screw-driver to shift ignition electrodes from the coil of ignition and to remove them.
3. To remove a washer.
4. To remove bolts with lock washers.
5. To remove the flame detector and to remove.
Installation.
1. To set the flame detector to position for installation, to connect to the power supply network according to the scheme and to fix by bolts and lock washers.
2. To delay bolts with effort 5 + 1 Nanometer.
3. To put on a washer and to level.
4. To establish ignition electrodes.
5. To establish a burner.
Manufacturer | Webasto |
Country of origin | Germany |
Weight | 0.5 kg |
Flame Detector Thermo 230/300/350 DW230/300/350 reviews
Be the first to write a review of this product!