Burner TH/DW350 24V

Buy Burner TH/DW350 24V

Part No.1320003A use for Thermo 350.032/042 DW 350.02 Alternative Part No.65477D

1320003A
In stock
$1,608.67

Burner.

In a burner there is an evaporation and preliminary burning of fuel.

Opening / closing and removal / installation of a head of a Burner.


CAREFULLY! In the ignition coil high voltage. Before opening it is necessary to disconnect plugs of a cable plait from sockets in the car, otherwise there is a danger to life. When the torch head is closed again, to connect plugs back.

Instruction. The heater is simple in service thanks to the opening burner head: having opened her, it is possible to get access to the following details:

• fuel pump and raspylitelny nozzle

• magnetic valve

• high-voltage coil of ignition

• ignition electrodes

• flame sensor

• combustion chamber

• the nozzle heater (if it is)

To open a burner head with the corresponding corner, it is necessary to disconnect electric cables to the limiter of heating and the sensor of temperature.

Opening / removal.

1. to separate electric connections with the limiter of heating and the sensor of temperature.

1. to weaken nuts so that it was possible to turn off bolts.

2. to turn off bolts.

3. to open a burner head.

4. if it is necessary, to take out the cotter pin and to remove a torch head

Closing / installation.

1. If the head of a burner has been removed, to hang it and to insert the cotter pin.

2. To close a burner head, having brought her into collected situation.

3. To adjoin bolts and to fix by nuts.

4. To delay nuts with effort of 7,5 Nanometers 1 Nanometers.

6. To restore electric connections with the limiter and the sensor of temperature.

Instruction: To watch that cables have been connected according to their flowers.

Replacement of a burner.
Instruction: Replacement of a burner in the heater installed in the car and removed from him is made equally.

Dismantling.

1. To disconnect a burner from an electrical network and to weaken fastening of a fuel-supply line.

2. To weaken nuts so that it was possible to cast away bolts.

3. To turn off bolts and to extend the cotter pin.

4. To remove a burner.

Installation.

1. To bring a burner into adjusting situation, to bring bolts and to fix temporary by nuts.

2. To insert the cotter pin according to the provided direction of turn.

3. To delay nuts with effort of 7,5 Nanometers + 1 Nanometer.

4. To connect fuel-supply lines.

5. To restore electric connections (the Instruction: to connect cables according to their flowers)

The heater needs to be checked regularly, no later than the beginning of a heating season.

Check of a head of a burner.

a) To check an inlet opening of air. To open a burner head:

b) To check the case inside for congestions of the fuel flowing through thinnesses.

c) To clean flame sensor eyes.

d) To check ignition electrodes.

e) To replace a nozzle.

Note:

to d) - to Replace curved electrodes.

to e) - At a deposit to reduce an interval of replacement of the fuel filter.

Manufacturer Webasto
Country of origin Germany
Weight 2 kg

Burner TH/DW350 24V reviews

Be the first to write a review of this product!