Burner Evo 40/55 petrol without pin

Applicability:

Webasto Air Top EVO40 & Air Top EVO55

In a burner fuel, evaporating from vaporizing laying, it is distributed on the combustion chamber. In the combustion chamber fuel-air mix burns down, heating thereby the heat exchanger.

Replacement of a burner:

Dismantling:

1. To remove the heater.

2. To remove laying.

3. To dismantle the control unit.

4. To remove the supercharger of air.

5. To unscrew two self-tapping screws and remove the holding plate.

6. To take out rubber consolidation of a plait of a pin of the incandescence/sensor of a flame from the heat exchanger, having pressed it.

7. To press rubber consolidation of a vaporizing element in the heat exchanger.

8. To carefully pull out a vaporizing element from an air intake tube, and then from the heat exchanger block.

9. To remove the fixing bracket and to pull out a pin the flame incandescence/sensor from a torch

10. To carry out works with the removed components.

Installation:

1. To insert a pin the flame incandescence/sensor into a torch (a wire opposite to an opening for consolidation) and to fix by the fixing plate.

2. To insert a torch into the heat exchanger and into a spherical pipe.

3. Establish a clamping bracket and two fixing self-tapping screws.

4. To tighten self-tapping screws with the moment of 4±0.4 Nanometers.

5. To install consolidation of the fuel highway in the heat exchanger.

6. To place wires of a pin of the heat/sensor of a flame in the corresponding opening of the heat exchanger.

7. To install consolidation of a pin of the heat/sensor of a flame in the heat exchanger case. Make sure that wire doesn't form a loop and has no provis.

8. To establish the supercharger of air.

9. To install the control unit.

10. To assemble the case.

11. To install the heater.

Manufacturer	Webasto
Country of origin	Germany
Weight	0.5 kg