Eberspacher AIRTRONIC D5 12v + mounting kit and control unit

Buy Eberspacher AIRTRONIC D5 12v + mounting kit and control unit

The air-operated auxiliary heater Eberspacher AIRTRONIC D5 12V is suitable for installation on the following vehicles: • Vehicles of all types (max 9 seats) and trailers to them • Construction machinery • Agreecultural machines. Agreecultural equipment • Boats, ships and yachts (only diesel heaters) • Cars equipped for habitation. 252361050000 25.2361.05.0000 25 2361 05 0000

252361050000

$1,200

Add to comparison table

Eberspacher AIRTRONIC D5 12v + mounting kit and control unit

Package Included:

- Heater

- Fuel pump

- Mounting kit

- Easy Start Select (control unit)

Composition of the heater AIRTRONIC D5 12V.

The heater consists of the following main components:

- Air blower

- The combustion chamber

- Heat Exchanger

- Control block

The principle of the AIRTRONIC D5 12V heater.

When enabled, the control lamp in the control lights up. The glow plug is turned on and the fan runs at low speed.

After 65 seconds, the fuel supply starts and the air-fuel mixture ignites in the combustion chamber.After 60 seconds after the detection by the combined sensor (combustion sensor) of the presence of flame, the pin electrode of the filament is disconnected. After that, the unit is in the normal operation mode.

In heating mode, the room temperature or the temperature of the intake air is constantly measured.If the temperature is higher than the value set on the control panel, the regulation starts.There are 4 stages of regulation, which ensures precise adjustment of the heat energy flow supplied by the heating device in accordance with the needs. The speed of the fan and the amount of fuel supplied correspond with the selected control stage. If the temperature is exceeded, even at the lowest stage of the regulation, the heater goes to the "OFF" control stage with the inertial fan run for about 4 minutes for cooling. Then the fan runs until the next start at minimum speed (recirculation mode) or turns off (fresh mode air).

When the heater is switched off, the test lamp goes out and the fuel supply is cut off.For cooling, the inertial run-out of the fan is provided for about 4 minutes. To clean the combustion chamber during the inertial run-out of the fan, a pinning electrode is turned on for about 40 seconds.

Special situation: If the fuel supply does not occur before shutdown or if the heater is located in the "OFF" stage, the heater goes into standby after the inertial run-out.

Weight

8 kg

Tags: 252361050000 Eberspacher AIRTRONIC D5 12V