Webasto Thermo Top Evo 5 Petrol
Preheater Webasto Thermo Top Evo 5 has a significantly smaller dimensions than the previous model, which allows you to install the heater in modern cars with extremely tight linkage of under-bonnet space. Engineers were able to reduce not only the overall dimensions, but also reduce fuel consumption by 30% compared with a series of Thermo Top C. Low cost, high teploproizvodimost, minimum dimensions and light weight made Top Evo 5 flagship among heaters for cars. Designed for cars with engine capacity of 2 to 4 liters.
Supplied with the heater:
1-Heater to replace the Thermo Top Evo 5 12V petrol 5 kW
2-circulation pump U 4847 econ 12V (OE 18 mm)
3-Pump-dispenser DP 42 12V (petrol and diesel) with mounting hardware
4-set fittings for connecting the heater 2 x 900 OE18mm, two spring collar OE25mm 2pcs-90 deg. h18mm
5-Pack with connecting fittings. Composition: corner fitting 900 x-2 PCs samozazhimnoj OE25mm yoke-6 PCs
6-Pack with connecting fittings. Composition: corner fitting 900-OE18h18mm-1 PC socket direct OE18h18 mm-1 PC clamp 25 mm OE samozazhimnoj-6 PCs
7-liquid Hose L = m OEvnutr = 18 mm, OEvnesh = 18 mm
8-nozzles for liquid pressure plate, two rubber seals, mounting screws
9-Pack with circulation pump U4847 econ, M6 cage nut M6 bolt bushing
10-Pack with exhaust clamps and mounting hardware
11-package with mounting hardware
12-Muffler exhaust OE22mm
13-exhaust Pipe D = 22, d = 25.5, L = 1000 mm
14-Pack with remote, metallized heat rings (red) 2 PCs.
15-Tube air intake OEvnutr 21.4 mm, L = 400 mm.
16-Pack with air inlet silencer clamp
17-Pack cable ties. 40 PCs
18-standard Bracket
19-pack connectors fuel nozzles
20-Tow wiring main (sealed)
21-cartridge fuse and relays (vnutrisalonnyj)
22-Tow circulation pump
23-a package with elements for power connection fan motor the oven compartment
24-Pack with toplivozabornikom
25-Fuel tube black 1, 5x5mm, L = 5 m.
26-package with documentation
Webasto Thermo Top Evo 5 consists of sledujushhihosnovnyh components:
-Air pump with control unit. Supercharger disassembly is not allowed!
-Burner
-Heat exchanger
-Pin plugs/flame sensor
-Temperature sensor and sensor overheating
-Circulation pump
-Dosing pump.
The principle of operation of the Webasto Thermo Top Evo 5.
Run the heater occurs via a switch-on signal from the control. Thermo Top Evo can run only by using a control with WBus bus, or via the PC-diagnostics of Thermo Test when starting the heater blower begin to function, circulation pump, and heater PIN. Then turn on pump. Gasoline heater runs with maximum load. Diesel same heater runs with minimal load and slowly accelerating to the maximum load. During the launch phase pin filament controls flaming. After maximum load mode pin filament monitoring sensor function performs the flame. Heater with achieving a certain temperature (approx. 80° c) goes into energy saving mode the partial load. If the temperature increases further, the heater
Heater | Mode | Thermo Top Evo - B | Thermo Top Evo - D |
||
5 kW |
4 kW |
5 kW |
4 kW |
||
Non EU certificates |
e1*2001/56*2006/119*0258*... e1*72/245*2006/96*5627*... E1 122R-00 0258 E1 10 R-03 5627 |
||||
Design |
Solvent evaporation from burner heater |
||||
Heating capacity |
Full load / Partial load |
5,0 kW 2,8 kW |
4,0 kW 2,8 kW |
5,0 kW 2,5 kW |
4,0 kW 2,5 kW |
Fuel |
Petrol EN 228 DIN 51625 | Diesel EN 590 |
|||
Fuel consumption +/- 10 % |
Full load / Partial load |
0,705 l/h 0,395 l/h |
0,560 l/h 0,395 l/h |
0,620 l/h 0,310 l/h |
0,495 l/h 0,310 l/h |
Nominal voltage |
12V |
||||
Operating voltage range |
11 - 16,5V |
||||
Nominal power consumption without circulation pump+/-10% (without fan) |
Full load / Partial load |
33 W 15 W |
21 W 15 W |
33 W 12 W |
21 W 12 W |
Permissible ambient temperature Wednesday: Heater-work Storage Metering pump:-operation-storage |
-40 ... +60 °C -40 ... +120 °C -40 ... +20 °C -40 ... +10 °C -40 ... +90 °C | -40 ... +80 °C -40 ... +120 °C -40 ... +30 °C -40 ... +90 °C |
|||
Permissible operating pressure of the coolant |
2,5 bar |
||||
Volume heat exchanger |
0,075 l |
||||
The minimum number of coolant |
1,50 l |
||||
The minimum volumetric flow for coolant |
200 l/h |
||||
CO2 in the waste gas (valid range) |
8 - 12,0 % of volume |
||||
Heater dimensions without mounting parts (tolerance ± 3 mm) |
L: 218 мм B: 91 мм H: 147 мм without fittings |
||||
Weight/unit with mounting kit |
2,1 kg / 8 kg |
Manufacturer | Webasto |
Country of origin | Germany |
Weight | 8 kg |
Categories: Prestarting heaters Webasto
Webasto Thermo Top Evo 5 Petrol reviews
Be the first to write a review of this product!